Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1252 point to multipoint connection

Is it possible to make with a 1252 a multipoint to point connection, on central building that connect two different buildings, and what about the antenna connections, there are three connections but is it possible to connect 2 antennas one for one building and the other for the other building ?

1 REPLY
Bronze

Re: AP1252 point to multipoint connection

On bridges set up in a point-to-point configuration, set the RTS threshold to 4000 on both the root and non-root bridges. If you have multiple bridges set up in a point-to-multipoint configuration, set the RTS threshold to 4000 on the root bridge and to 0 on the non-root bridges.

Examples

This example shows how to set the RTS threshold on a bridge to 4000 bytes:

bridge(config-if)# rts threshold 4000

This example shows how to set the RTS retries count to 3:

AP(config-if)# rts retries 3

This example shows how to reset the parameter to defaults:

AP(config-if)# no rts

191
Views
0
Helpful
1
Replies