I have a AP350 in my home connect to a switch that is connected to a cable modem. All PC's that I connect to the switch get a different IP address thru DHCP. My problem is that I can not get more than one device to Associate with the AP. I have two 340 PCMCIA's and two laptops. I would like them both to Associate so that both can be used. I also have a third party PCMCIA card for an HP Jornada 720. It works fine with either the 3rd party or the 340's, but the laptops must be turned off for it to associate. What am I doing wrong?
IntroductionHow to use the Wireless LAN Controller Configuration Analyzer (WLCCA)
Javier Contreras is a Senior Tech Lead for the Wireless Business Unit in Cisco, with over 2 decades of experi...
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...