Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

APs Fail to Reconnect After a Power Failure

I have some AP-350's failing to reconnect to their parent switches - Cat 5000's and Cat 5500's - after a power failure and resumption. Firmware is 11.10T. It looks like it consistently happens when power is fed from the in-line power injector but I'm not sure. Has anyone seen this before?

1 REPLY
Cisco Employee

Re: APs Fail to Reconnect After a Power Failure

Are you using in-line power or power injector?

Does AP comeup at all with in-line power?

There is one issue reported where re-connect of eth cable to AP does resolve the issue..

Try to use the power injector and see the results

136
Views
0
Helpful
1
Replies
CreatePlease to create content