Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

APs not displaying CDP information in WCS on newley configured Switches

HI

We're changing our edge switches from vlan 1 flat network to layer 2 trunk switches.

1 trunk for data 1 for voice.

New native vlan is 555.

Since starting this, the APs are not displaying any CDP or connected users in WCS.

Vlan 1 is being trunked.

WCS and WISM are using ver 7.

Any ideas?


Cheers

2 REPLIES
Cisco Employee

Re: APs not displaying CDP information in WCS on newley configur

Hi Craig,

Are the APs connected to trunk ports or access mode?

If trunking is not needed on AP switchport, can you change to access-mode?

I read, there are issues on CDP when AP is connected to trunk port and native vlan is not 1.

Access mode on switchport would fix this.

Have good day.

Serge

Cisco Employee

Re: APs not displaying CDP information in WCS on newley configur

Try refressing the configurations from the controllers and then try the CDP..

Regards

Surendra

220
Views
0
Helpful
2
Replies