Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Architecture issue with 2106 controller

I have a 2106 controller. I want to connect two LWAPP 1131 directly on the two POE ports. I also want to connect a port on a Firewall in order to administrate the controller through the firewall.

The issue is that the management interface must be accessible for the AP and for a PC through the firewall. But the management interface can be assign to only one port.

Any idee?

  • Other Wireless - Mobility Subjects
1 REPLY
Cisco Employee

Re: Architecture issue with 2106 controller

Hi Friend,

Management ip address should be reachable by APs and not interface. So you can map your management interface to port 1 and connect you APs to port 7 & 8 and they will join your controller.

If I am not able to understand your doubt please come back again with the same.

HTH

Ankur

*Pls rate all helpfull post

114
Views
0
Helpful
1
Replies
This widget could not be displayed.