i have aps 1242 with wireless client associated and an ap1242 in workgroup bridge mode associated too , can the ap in workgrp mode roam between different AP1242 ? if yes is there some special conf needed ?
normaly the client decide wich ap to associate with , does ap in workgrp have the same capacity ?
Re: are AP1242 in workgpbridge mode roaming capable ?
Try this out;
Q. How do I configure my AP acting as WGB to dynamically switch between parent access points based on signal reception?
A. Use this command in order to configure the Workgroup Bridge as a mobile station:
When you enable this setting, the Workgroup Bridge scans for a new parent association when it encounters a poor Received Signal Strength Indicator (RSSI), excessive radio interference, or a high frame-loss percentage. With the use of these criteria, a Workgroup Bridge configured as a mobile station searches for a new parent association and roams to a new parent before it loses its current association. When the mobile station setting is disabled, the default setting, the Workgroup Bridge does not search for a new association until it loses its current association.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...