Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to ask questions and learn about the Cisco OfficeExtend 600 Series Solution that comprises the Cisco Aironet® 600 Series OfficeExtend Access Points, Cisco wireless controllers and the Cisco Wireless Control System with Cisco expert Bruce Tiff. The Cisco Aironet 600 Series OfficeExtend Access Point is purposely designed for the teleworker by supporting secure corporate data access and also allows connectivity for personal home devices with segmented home-traffic support. The access point connects to the home's broadband Internet access and establishes a secure tunnel to the corporate network so that remote employees can access data, voice, video, and cloud services for a mobility experience consistent with that at the corporate office. There is no need for special VPN software on your corporate devices while using the Aironet 600 Series Access point.
Remember to use the rating system to let Bruce know if you have received an adequate response.
Bruce might not be able to answer each question due to the volume expected during this event. Remember that you can continue the conversation on the Wireless Mobility - sub-community discussion forum shortly after the event. This event lasts through April 6, 2012. Visit this forum often to view responses to your questions and the questions of other community members.
That capability is still there in R7.2 and has been added to the WLC GUI whereas previously it was via the CLI only. In addition we have expanded the capability to support up to 2 dedicated ethernet ports now ias needed. Each can be placed on separate VLANs if needed. Hope this helps.
The mobility anchor option for a remote-LAN has been removed. It is still there for WLAN, but not for the wired. There was a bug ID to remove this option in 7.2, I will try to find it. The issue is that it was removed in 7.2, buy if you upgraded from 7.0.x to 220.127.116.11, the existing mobility anchor would still be there and working, but you no longer can add, modify or delete a mobility anchor from a remote-lan. The fix would be to downgrade back to 7.0.x. This has been removed in both the GUI and CLI.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...