I would like to ask you if it is possible to configure in a remote AP the controller IP address by DHCP. I have gotten to assign an AP IP address and default gateway but, I think It don't know the controller IP address and the AP don't get to enjoy it by H-REAP. Ap is in a branch office and I can't connect to it by console, do you know how could do it?
Configure a local dhcp scope to offer option 43, DNS name resolution, or hard code the AP with the address of the controller. Refer to the configuration guide for your WLC code version for detailed information on this.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...