I currently have multiple 1200 series AP's. For some reason I cannot see any other AP's except the AP I am currently on in the association table. Also when trying to puch config to other ap's I fall into an INACTIVE state.
Check the APs association table and make sure that it sees the other two APs. If it does not, then you may need to reconfigure the APs as possibly the configuration could be stuck or corrupted. There could as well be interference or firmware issues. Check your firmware to see if you are on the latest build.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...