Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. And see here for current known issues.
I note that in the WLC v6.0 config guide support for EAP-FAST is listed under the workgroup bridge configuration section.
Has anyone been successfull in getting this working ? or have a config example ?
I've had limited success on setting up a WGB wto Auth via WPA2-PSK , but no luck with EAP-FAST.
Documentation for this stuff seems to be a bit light on.
WLCs are 4402's running v6.0 with ACS 4.2 as my auth server.
Use this in your WGB config:
eap profile eapfast method fast
dot11 ssid authentication open eap eap_methods authentication network-eap eap_methods authentication key-management wpa authentication client username password dot1x eap profile eapfast
That should do it.
I've had success using a few different 12.4 IOS versions but not on 12.3(7)JA3
Also works with Dynamic VLAN Assignment from ACS
Please mark the Question as Answered, if the provided information by Peter is correct and it helped. By doing that others can take benefit as well.
Community Manager – Wireless