I have exactly the same setup on a large number of clients, and they all work fine; however when this one tries to authenticate to the network it fails. When I check the ACS (3.3) log it claims that the client is using an EAP type that is not configured and fails the attempt, however if I check passed authentications, it also shows that the authentication was sucessful.
I have exactly the same setup on all clients, so I can't see why this one does not work. I have removed and re-installed the drivers and ACU a few times and have double checked the profile setup, but to no avail.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...