Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Authentication on 1300 Series

I´ve already installed a couple of these device, one as a root and the other as non-root, i´m authenticating the devices with mac address over the root-brigde but i have some troubles with some devices one of error is here: Interface Dot11Radio0, Deauthenticating Station 000c.f14c.9e08 Reason: Disassociated because sending station is leaving (or has left) BSS. i hope anyone knows about it. and i want to know too if i can authenticatink devices over the not-root.

Thanks a lot

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Authentication on 1300 Series

Enhanced authentication servicesSet up non-root bridges to authenticate to your network like other wireless client devices. After you provide a network username and password for the non-root bridge, it authenticates to your network using LEAP, Cisco's wireless authentication method, and receives and uses dynamic WEP keys.

http://www.cisco.com/en/US/products/ps5861/products_configuration_guide_chapter09186a008024a923.html

1 REPLY
Silver

Re: Authentication on 1300 Series

Enhanced authentication servicesSet up non-root bridges to authenticate to your network like other wireless client devices. After you provide a network username and password for the non-root bridge, it authenticates to your network using LEAP, Cisco's wireless authentication method, and receives and uses dynamic WEP keys.

http://www.cisco.com/en/US/products/ps5861/products_configuration_guide_chapter09186a008024a923.html

145
Views
0
Helpful
1
Replies
CreatePlease login to create content