Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1136
Views
3
Helpful
3
Replies

Autonomous -> LWAPP Upgrade Tool & Vista

Toivo
Level 1
Level 1

‎05-06-2008 10:45 AM - edited ‎07-03-2021 03:49 PM

I tried to install the v. 3.4 upgrade tool on Vista Business 64 bit. The installation fails with a pop-up titled "Severe" with error "Error in opening iput file."

The real problem I'm having is that I can't uninstall the failed installation. It shows up in the installed programs list, but upon uninstalling pops up with "Setup Initialization Error" "Setup is unable to find _SETUP.DLL, which is needed to complete the installation. Error 103."

Any advice on how I can excise this thing out of my system?

Labels:
0 Helpful
3 Replies 3

dennischolmes
Level 7
Level 7

‎05-08-2008 04:47 AM

try running the uninstall in windows XP compatibility mode.

Toivo
Level 1
Level 1
In response to dennischolmes

‎05-08-2008 05:03 AM

Unfortunately that didn't do the trick. I did look at the uninstall.bat file and tried running the isuninst command manually with the same options and compatibility mode, but it just immediately exists without doing anything.

0 Helpful

dennischolmes
Level 7
Level 7
In response to Toivo

‎05-08-2008 05:08 AM

Looks like a manual uninstall and a registry clean for you my friend. Good luck.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card