I just received a new AIR-PWRINJ3 for my AP350 (someone lost the original one) and when I plug it in I get power, but nothing on the ethernet side. I've verified that the CAT5 cable, port and Access Point are in good working condition. Could it be a bad injector? I have a spare injector and when I plug it in place of the other one I get power on the AP. Thanks
The Power Status Indicator is green and there is nothing on the Device Status Indicator. This is the 2nd unit that I've tried with no luck. Vendor says now to call Cisco because the part # is "the correct one for replacement" for the AP350 and the 48 port blade (4006) doesn't have inline power.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...