Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Band-Select in 6.0.182.0

Is anyone successfully using Band-select ? I was reading the 6.0.182 release notes and found this comment:

"Band Select and Load Balancing CLI Commands

The config band-select and config wlan band-select CLI commands appear in controller software

release 6.0.182.0, but they are not supported and should not be used. Also, you can ignore the Band

Select Stats information in the output of the show ap stats {802.11a | 802.11b} Cisco_AP command."

Link to the release notes(page 22):

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn601820.pdf

1 REPLY
Anonymous
N/A

Re: Band-Select in 6.0.182.0

194
Views
0
Helpful
1
Replies