Hello, One question: I know when I configure a bridge or access point as a repeater, I have half the 11 Mbps. but, when i connect a repeater to a repeater : What's the speed I get? stilll 5.5 Mps or it drops to 2.8.
Every time you use a single-frequency repeater by itself you lose half (50% - 60%) of the throughput. Connecting one repeater to another repeater over the air results in losing half of the remaining throughput on each hop you take. By contrast, if you had a two-frequency repeater (for example, one box with two wireless cards) you would only lose around 20% of the throughput on each hop.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...