Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Batch WLC CLI commands

I'm building scripts to help automate large deployments. Is there a way to execute a CLI command on all registered APs, like with a wildcard?

for example, to set a custom power level on multiple APs, it's necessary to do this:

config 802.11b disable AP01

config 802.11b txpower ap AP01 3

config 802.11b enable AP01

config 802.11b disable AP02

config 802.11b txpower ap AP02 3

config 802.11b enable AP02

config 802.11b disable AP03

config 802.11b txpower ap AP03 3

config 802.11b enable AP03

Is it possible to do something like this?

some command to disable all b/g radios

config 802.11b txpower ap [wildcard] 3

some command to enable all b/g radios

1 REPLY
Cisco Employee

Re: Batch WLC CLI commands

config 802.11b disable network (for all of them)

(Cisco Controller) >config 802.11b txPower global ?

auto Enables auto-RF.

once Enables one-time auto-RF.

Enter transmit power level

this was on a WLC running 5.0.148.2, but I think the commands are in lower versions.

206
Views
0
Helpful
1
Replies