Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Booting Problems on WLAN controller 4400

I Got a new WLAN controller 4400 from out of the BOX from one of the vendor, its not booting completely its giving me the following error

PHY DEVICE : Found Intel LXT971A PHY at 0x01

FEC ETHERNET

IDE: Bus 0: OK

Device 0: not available

Device 1: not available

Booting Primary Image...

Press <ESC> now for additional boot options...

** Partition 4 not valid on device 0 **

** Unable to use ide 0:4 for fatload **

** Partition 4 not valid on device 0 **

** Unable to use ide 0:4 for fatload **

bzImage Image Integrity Check Failed(Bad Magic Number). Hanging

and its just sitting there, Please help trying to open a TAC case but i dont think it as smartnet

1 REPLY
Cisco Employee

Re: Booting Problems on WLAN controller 4400

Hi Friend,

This error generally indicates flash memory failure. I suspect you'll require hardware

replacement.

Regards,

Ankur

953
Views
0
Helpful
1
Replies
CreatePlease to create content