Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bought an HWIC-AP-A/G off eBay ... My mistake!!!

I'm a sucker for Cisco gear and thought I found a good deal when I ran across a HWIC-AP-A/G that would have been a great addition to my 1841. I "rammed" it in it's little slot and it spewed these terrible words:

Feb 18 03:45:48.231: %HW-2-OBSOLETE_HW_VER: Module Version in 0/0/-1 is obsolet

e

*********************************************************************

* IMPORTANT !!! *

* The module in bay/slot/sub_slot = 0/0/-1 is obsolete and must *

* be returned via RMA to Cisco Manufacturing. If it is a lab unit, *

* it must be returned to Proto Services for upgrade. *

*********************************************************************

I have never seen this message in my life. Anyone know what I may have purchased here and if I can remedy the situation?

Thanks a bunch!

Bob

1 REPLY
New Member

Re: Bought an HWIC-AP-A/G off eBay ... My mistake!!!

Please go to http://www.cisco.com/en/US/products/ps5853/products_data_sheet0900aecd8016a59b.html and take a look at the Table 6 to see if this particular module is supported by 1841. If it is listed as supported then the HWIC you purchased must be a bad unit. That may be why you are seeing words like "obsolete" and "RMA".

HTH

225
Views
0
Helpful
1
Replies