Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BR1310 power injector red when power is removed, and restored.

Hello,

Have a set of BR1310G-A-K9-R with AIR-PWRINJ-BLR2 injectors, feed by P/N 34-1537-02 REVA0.

If 1310 connected to injector, powered by the transformer (mentioned above)when power applied, red light between power plug and coax connector is red, no lights on back of 1310. If I then disconnect the power plug from the injector, and reconnect, same light turns green.

Any suggestions? I didn't purchase the equipment, perhaps the parts listed above are not compatible?

Thanks for any help,

Jeff

Edit missing number.

1 REPLY
Bronze

Re: BR1310 power injector red when power is removed, and restore

Check for loose connections.the maximum distance between BR1310 and power injector is 100m.If this doesnt work Try to replace the power injector and see if it works.Perhaps replacing the power injector mostly would resolve.

382
Views
0
Helpful
1
Replies