Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BR342 flash upgrade failure

After successfully uploading the flash via ftp, the image was decompressed and in the middle of the process it went south. I reviewed other posts and found the unit had been sent to the factory or the owner was out of luck. Is there a do-it-your-self fix available for a soild red status light? How about a boot strap inside the box to set the console to default settings? Please advise. I have a temporary link for this customer, but need to advise of additional expenses if necessary.

1 REPLY
Bronze

Re: BR342 flash upgrade failure

You will have to either send the bridge back to the factory for repair or you will have to acquire a replacement for the bridge. There is not a do-it-yourself fix for this problem.

110
Views
0
Helpful
1
Replies