Configure the AP 350 with a vlan for the SNA machines. You need to associate this vlan with an SSID later. And on the vlan setup webpage you can configure the priority of this particular vlan. Acceptable values are
4. Excellent effort
5. Controlled load
6. Interactive video
7. Interactive voice
8. Network control
Once you choose a type of priority, you can go to protocol filters page, and selecto Quality of Service, For the priority class you chose, set the CWmax and CWmin values. Wireless uses congestion avoidance, so these factors actually determines the approximate random time, for which it waits, before sending data. For voice and delay sensitive traffic such as SNA, you should set the CWmin to a lower value, inorder to account for delay.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...