Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

bridge errors

Hello, i have few questions on wireless work group brid:

1. %DOT11-4-CANT_ASSOC: Interface Dot11Radio0, cannot associate: assoociate response status (18) unsupported data rates

    what does the error indicate on a 1310 acting as work group bridge

2.  we can see the dot11radio 0 inteface in reset status on the bridge

     Interface                  IP-Address      OK? Method Status                Protocol

BVI1                       192.168.121.5     YES NVRAM  up                    up     

Dot11Radio0                unassigned      YES NVRAM  reset                 down   

FastEthernet0              unassigned      YES NVRAM  up                    up     

what could cause it and how to correct it

3. on 5500 wireless lan controller, we see some of the work group bridges in excluded mode after initially seen normally.

   what causes this & best way to correct it

4. when we check the dot11 associations on the bridge, it indicates some activity timeouts.

    do we need to set them manually and what is their purpose

228
Views
0
Helpful
0
Replies
CreatePlease to create content