Bridge functionality with Cisco 1200 AP in lightweight
Autonomous 1200 AP [running Cisco IOS]can work as a bridge unit. When I cpnvert this AP to LWAPP will I get the bridge functionality? In case of 1300 AP/Bridge LWAPP is supported only for AP and not for bridge.
If I can get the bridge functionality on 1200 LWAPP can I use it in conjuction with 1000 LWAPP?
Q. Can I configure a Cisco IOS Software-based AP as a workgroup bridge and associate with Lightweight AP Protocol (LWAPP)-based APs?
A. Cisco IOS Software-based APs (autonomous APs) that are configured as workgroup bridges associate only with Cisco IOS Software-based APs. They cannot associate with LWAPP-based APs. Cisco IOS Software-based APs that are converted to lightweight mode also do not support workgroup bridge associations. This is because LWAPP devices cannot communicate with non-LWAPP devices at all.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...