Bridge wireless traffic to local switch

[Ratchapas Shatsa-Nga]

Hi,

I'd like to configure WLC 2504 and CAP2602 with 2 SSIDs.

2 SSIDs have Sale (VLAN10) and Support (VLAN20).

Normally a data of client will pass through in tunnel but I'd like traffic into local switch.

Management (VLAN1), Sale (VLAN10), and Support (VLAN20).

AP connected to port on switch that configured switch mode access and switch access vlan 1. It's working

I don't want VLAN10 and VLAN20 in tunnel back to wlc, what should I do?

Because when wlc is down, the wireless system cannot serve a service.

Thank you

[Sandeep Choudhary]

Hi Ratch,

As per my knowledge, Its not possible in local mode for APs but H-REAPs/Flexconnect can switch client data traffic locally.

Check these guides:

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81680-hreap-modes.html#cl

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/71250-h-reap-design-deploy.html

Regards

Dont forget to rate helpful posts