Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bridging(1300 series)

Hi I'm Serge and i configured 2 Cisco 1300 series bridges for Point 2 Point connectivity.

The lattency on the link has an average of 3 ms.

Signal strength of:77 dbm

the connectivity fro both side is good as ping test.

But when i put some data in trasnfer it take too much time.

i trasferd a file of 16.5 MB in about 7 mn.

pls help me find a solution about that radio link asap.

thx!

4 REPLIES
New Member

Re: Bridging(1300 series)

Make sure the bridge is configured for Maximum Throughput whcih enables bridge to work at optimum speed.

New Member

Re: Bridging(1300 series)

Can you post your configs?

Seth

New Member

Re: Bridging(1300 series)

Hi, did you manage to resolve the latency problem? I'm having exactly the same issue here.

New Member

Re: Bridging(1300 series)

I had a lot of Interferance @ the site and pls make sure the transfer rate is on default for better throughput if u have some kinda interferance. Thx

Sergent_02

120
Views
0
Helpful
4
Replies