I have a question about setting up VLANS on the AP's. I've configured a user VLAN on an AP w/ 12.02t1 code. I've also tied a new SSID to the VLAN. I'm trying to migrate users from our old configuration where broadcast SSID was available to a new configuration where they would have to know the SSID for the VLAN that they are able to join.
I can't find the setting to enable this under the SSID or the VLAN configuration. The only thing I can find is on the global hardware page to allow or disallow broadcast SSID.
I'd like the AP to be setup so it would support both user groups - the old ones who use the broadcast SSID and the new ones who have their machines configured with a static SSID. Is this possible?
Thank you for the link. I found a similar document last week that explained the difference b/w the primary and secondary SSID's. Only one SSID can be broadcast in the beacon frame so I can setup that SSID as the primary and include the new SSID's as secondaries.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...