Bulk flexconnect AP changes

[Daniel Graham]

Is there a way to make AP mode change to flexconnect / flexconnect vlan mappings to a group of AP's at the same time?

[Rasika Nayanajith]

Hi Dan,

I do not think so. (not sure any prime template can be used for this though)

Anyway you have to change AP mode to Flexconnect individually, do the VLAN mapping as additional step in that task.

HTH

Rasika

**** Pls rate all useful responses ****

[Stephen Rodriguez]

There might be a template you could push from PI that will set the vlans on the AP if it's already in FlexConnect mode.

I usually just do those changes from the cli myself though.

Steve

Sent from Cisco Technical Support iPhone App

[Saravanan Lakshmanan]

in 7.5 and 7.6 have a feature where you can push vlans to flexconnect group where the flex APs were added.

http://www.cisco.com/en/US/docs/wireless/controller/7.5/config_guide/b_cg75_chapter_010001001.html#d30073e1468a1635

[Scott Fella]

Just to add... You can create a cli command script to change the mode if the access point from local to FlexConnect and then change the native vlan then add the WLAN to vlan mapping. I put something out on the forums a while back to change the WLAN to vlan mapping which might help.

https://supportforums.cisco.com/thread/2221117

Sent from Cisco Technical Support iPhone App