Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bulk flexconnect AP changes

Is there a way to make AP mode change to flexconnect / flexconnect vlan mappings to a group of AP's at the same time?

4 REPLIES
VIP Purple

Bulk flexconnect AP changes

Hi Dan,

I do not think so. (not sure any prime template can be used for this though)

Anyway you have to change AP mode to Flexconnect individually, do the VLAN mapping as additional step in that task.

HTH

Rasika

**** Pls rate all useful responses ****

Re: Bulk flexconnect AP changes

There might be a template you could push from PI that will set the vlans on the AP if it's already in FlexConnect mode.

I usually just do those changes from the cli myself though.

Steve

Sent from Cisco Technical Support iPhone App

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Cisco Employee

Bulk flexconnect AP changes

in 7.5 and 7.6 have a feature where you can push vlans to flexconnect group where the flex APs were added.

http://www.cisco.com/en/US/docs/wireless/controller/7.5/config_guide/b_cg75_chapter_010001001.html#d30073e1468a1635

Hall of Fame Super Silver

Re: Bulk flexconnect AP changes

Just to add... You can create a cli command script to change the mode if the access point from local to FlexConnect and then change the native vlan then add the WLAN to vlan mapping. I put something out on the forums a while back to change the WLAN to vlan mapping which might help.

https://supportforums.cisco.com/thread/2221117

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
435
Views
0
Helpful
4
Replies