Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cabling Issue

We were using UC4800 universal clients connected to P.C.'s and printer via straight thru ethernet cables to attach to the network(AP4800E). Because Cisco no longer manufacures the UC4800E we purchased the Air-WGB350. It appears that we now have to use a crossover cable when attaching these to P.C.'s and printers. Is there a switch, software or hardware, that allows me to use a straight thru ethernet cable?

1 REPLY
New Member

Re: Cabling Issue

Either replace the (current) straight-through cables with crossover cables, or (if it's a cable run) you could probably get away with an inline coupler & short crossover on the end of the existing cable.

136
Views
0
Helpful
1
Replies