Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
sin
New Member

Can a Flexconnect (h-reap) survive reload while in standalone mode

I have searched and asked round for this the last weeks. Can't find the answer.

When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?

Is it possible to make a setup with i.e. WPA/PSK where the AP keeps working after a reload in standalone mode ?

Chears

Rasmus

Everyone's tags (4)
3 REPLIES
Hall of Fame Super Gold

Can a Flexconnect (h-reap) survive reload while in standalone mo

When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?

When your WAN link(s) goes down and your FlexConnect (H-REAP) WAP reboots, it will not service anything/anyone.

sin
New Member

Can a Flexconnect (h-reap) survive reload while in standalone mo

Thanks. That was what I inspected but could not find any documentation for it.

Cisco Employee

Can a Flexconnect (h-reap) survive reload while in standalone mo

After reboot it is expected that hreap/flexconnect AP to retain the config and serve local clients, if it is not doing so then it is broken. However, this behavior is not documented in cco.

679
Views
0
Helpful
3
Replies
CreatePlease to create content