Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
Is it possible to use an AP340 IOS Image for a BS340 ??
This Question has been asked before, but there was no definit Answer
Does anyone knows if it works , for sure ??
I Tested it via the HTTP GUI, the LED's where flashing(as Uploading), but at the end
the Old 8.52 was Active ! (even after reboot).
Best regards & thanks in Advance
Netwok Consulting Engineer
I dont see any way to do it.