Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Can not turn off autonegotiation

I have a WLC 4402 that I upgraded to 6.0.199.4 from 4.2.207.0

Under ports it shows that I am mirroring port 25.  Physical mode for the port is set to auto and it will not let me set it to 1000/full.

Thanks

1 REPLY

Re: Can not turn off autonegotiation

The port mirroring, at this time, seems to be a cosmetic issue.  We removed the ability to do port mirroring in the 440x platform as it has never been supported above the old 4000/4100 series controllers.

As for the setting of the port speed/duplex, this was also removed.  If you set the connected switchport to auto/auto, they will negotiate to 1000/Full

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
165
Views
0
Helpful
1
Replies
CreatePlease to create content