Once I upgraded to WCS 184.108.40.206 I can no longer change the destination file location when I run reports. The reports seem to run on schedule but they end up in the default location of C:\WCSFTP\reports\. I would like to change that to my E: where I have more space to save reports. Before version 220.127.116.11 I was able to do this.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...