I'm trying to turn off the LED on a Cisco Aironet 1141 p/n AIR-AP1141N-A-K9. This is a standalone AP and from the CLI I'm issuing this command:
ap(config)#led display off
The LED does not turn off after typing this command. If I do `show run' it shows up in the config so the command was accepted. Is there a different way to turn off the LED? I'm running IOS Version 12.4(21a)JA1.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...