Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I need your feedback urgent please,
Can we create Mobility Group between WISM2 and WLC 5500
Firmware for WISM2 > 22.214.171.124
Firmware for WLC5500 > 126.96.36.199
I created Mobility Group with (IP address , MAC Address and Mobility group name) for Foreign Controller. if any configuration required from my side.
Wait your feedback urgent please
Yes I have done this before. The hardware should not be the issue. Plus those versions of code I have personally created MGs but with the reverse 7.4 on my 5500 and 6.0 on my WISM2. I can;t see this being an issue.
Controllers do not have to be of the same model to be a member of a mobility group. Mobility groups can be comprised of any combination of controller platforms.
Thats enough :)
Dont forget to rate helpful posts