Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

Hall of Fame Super Silver

Can you hard code the speed and duplex on lightweight access points

I have a client that want to set the spped and duplex on the switch port. Is there a way you can configure the fastethernet port on a lightweight access point for speed and duplex.

-Scott
*** Please rate helpful posts ***
1 REPLY
Bronze

Re: Can you hard code the speed and duplex on lightweight access

Try this step

configure terminal

Enter global configuration mode.

Step 2

interface fastethernet0

Enter configuration interface mode.

Step 3

speed {10 | 100 | auto}

Configure the Ethernet speed. Cisco recommends that you use auto, the default setting.

Step 4

duplex {auto | full | half}

Configure the duplex setting. Cisco recommends that you use auto, the default setting.

Step 5

end

Return to privileged EXEC mode.

Step 6

show running-config

Verify your entries.

Step 7

copy running-config startup-config

188
Views
0
Helpful
1
Replies
CreatePlease to create content