cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
840
Views
0
Helpful
4
Replies

Cannot connect to wlc4402 via console - Hardware failure?

nelmalisboa
Level 1
Level 1

Hi all,

I made a lot of tests during some days with a wlc4402 and everything was ok.

One day when I tried to reset the system I had a lot of errors (see attach) and could not go on. After changing the image the following output appeared: "RAM Disk Image Integrity Check Failed (Bad Magic Number) Hanging". Now I have no response from the controller.

Somebody already had this kind of problem?

4 Replies 4

carenas123
Level 5
Level 5

Try upgrading the controller to 4.0.1.155 or or 3.2.x.x.

kevinzhu74
Level 1
Level 1

I want to the result,because I met the same question,can not connect to the console after the failed of upgrade the image.

and I have to said,when the console said no ennough flash room. I reformat the flash (press ESC)

so ,pls help me!!!!!!!!!!!!

thank you.

I want to the result,because I met the same question,can not connect to the console after the failed of upgrade the image.

and I have to said,when the console said no ennough flash room. I reformat the flash (press ESC)

so ,pls help me!!!!!!!!!!!!

thank you.

astanislaus
Level 2
Level 2

What is the solution to this problem? I have the same problem. was it a H/W failure?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: