Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Cant see NME-AIR-WLC12-K9 ???

I just fired up a new 2821 ISR with an NME-AIR-WLC12-K9 in slot 1. Problem is, I can't see the controller. Neither sh hard nor sh run show any indication that the controller is present. What stupid little thing am I missing?

Router is running c2800nm-advsecurityk9-mz.124-16a.bin.

Thanks.

Mark

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Cant see NME-AIR-WLC12-K9 ???

Hi Mark,

I think it is the IOS;

Routers: Cisco IOS Software Release 12.4(3)T and later (from what I have read and seen the T is very important)

From this doc;

Cisco Wireless LAN Controller Modules

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet0900aecd80364432.html

Hope this helps!

Rob

2 REPLIES
Hall of Fame Super Red

Re: Cant see NME-AIR-WLC12-K9 ???

Hi Mark,

I think it is the IOS;

Routers: Cisco IOS Software Release 12.4(3)T and later (from what I have read and seen the T is very important)

From this doc;

Cisco Wireless LAN Controller Modules

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet0900aecd80364432.html

Hope this helps!

Rob

Community Member

Re: Cant see NME-AIR-WLC12-K9 ???

Rob,

You're right. I've loaded 12.4(15)T1.

Mark

267
Views
0
Helpful
2
Replies
CreatePlease to create content