Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CAP-2602 not registering with WLC4402

I have a WLC model 4402 running 7.0.235.3. I am trying to make a CAP2602 to join the WLC but it is unable to. Doesn't the 4402 with this software support the 2602? The WLC has a license for 12 AP's, only 9 in use. Currently there are only AIR-LAP1131 connected to the WLC.

The debug on the WLC shows this;          

*spamReceiveTask: Aug 14 08:16:07.133: 00:3a:9a:ab:c0:74 Received LWAPP DISCOVERY REQUEST to ff:ff:ff:ff:ff:ff on port '29'

*spamReceiveTask: Aug 14 08:16:07.133: Ethernet Source MAC (LRAD):      00:3A:9A:AB:C0:74

**spamReceiveTask: Aug 14 08:16:07.134: 00:3a:9a:ab:c0:74 Discarding discovery request in LWAPP from AP supporting CAPWAP

The CAP2602 gets its IP from the switch, and keeps on changing IP's all the time. I am able to ping it until it changes IP.

Everyone's tags (2)
3 REPLIES
New Member

CAP-2602 not registering with WLC4402

I can answer this myself, after some checking I found out that the last software-version for WLC4402, which is 7.0.240, does NOT support the 2602 access-points according to this document,

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn7_0_240_0.html#wp784295

Hall of Fame Super Gold

CAP-2602 not registering with WLC4402

2600 AP requires firmware 7.4.X.

7.4.X code is supported on the 2504/5508/WiSM-2 and later.  It's not supported in 4400/WiSM-1.

CAP-2602 not registering with WLC4402

Hello,

As per your query i can suggest you the following solution-

The controller software is factory installed on your controller and automatically downloaded to the access points after a release upgrade and whenever an access point joins a controller. We recommend that you install the latest software version available for maximum operational benefit.

Change the IP address of the management interface.

Hope this will help you.

1413
Views
0
Helpful
3
Replies