My cb21ag -E never works at 100mv, instead the maximum is 63mv. Is there any way to crank up the power to 100mv? The range on this card is rather poor actually, I was hoping for massive range with the advertised power and receiver sensetivity. Why is it not delivering? also my card says rev A0. does any one know the difference in later models and the power output for different versions (ie america, japan and world).
A lot of questions there, i hope someone knows the answers
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...