I use two 1310 aironet access point, the 1st link to my network by the ethernet interface is a root bridge and the other is a non root bridge. I'm using Cisco Works LMS to monitor my network. Right now i can see the root bridge in my map but i can't see the non root bridge. All the settings for CDP are enable on each interface on both access point. For best result i know that Cisco recommends to disable CDP on the radio interface but right now i am doing test and i will really appreciate to see the non root bridge in my map.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...