Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Certificate errors on autonomous to lightweight conversion

I have begun testing the conversion of our Aironet 1130 AP's from autonomous to lightweight mode. The converstion tool runs successfully and the converted AP correctly discovers the controller. Upon an LWAPP join request, however, the controller (a 4404 100 AP model) reports back "LWAPP Join-Request does not include valid certificate." The upgrade tool made mention that it created all the appropriate certificates.

Suggestions?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Certificate errors on autonomous to lightweight conversion

You can (did you try) ensuring that the date/time in the controller is current (use NTP whenever possible). If the date/time is off, the certs may bnot be within a valid date range.

2 REPLIES
New Member

Re: Certificate errors on autonomous to lightweight conversion

You can (did you try) ensuring that the date/time in the controller is current (use NTP whenever possible). If the date/time is off, the certs may bnot be within a valid date range.

New Member

Re: Certificate errors on autonomous to lightweight conversion

Sure enough, it was time related. Thank you for your assistance.

132
Views
0
Helpful
2
Replies