Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Change channel on Aironet 1300

I'm trying to use the http gui to change the channel used on my AP, but cannot make it happen.  I've
tried changing the dropdown back from Least Congested to a specific channel, no luck.  And I've tried limiting the channels used in the Least Congested search, no luck.  Both just bring back a blank screen, at this URL   http://{APADDRESS}/channel+least-congested+2417%5Binterface%2fDot11Radio0%5D%0Awrite+memory+quiet%0A  or http://{APADDRESS}/channel+2417%5Binterface%2fDot11Radio0%5D%0Awrite+memory+quiet%0A

I'm fighting lost connectivity when two radios (all are 1310s) are in direct opposite directions of my main multipoint radio, facing each other.  When I unplug either radio, the other works fine.  I'm unable to change the channel on either radio, and cannot upgrade to latest IOS either (my main multipoint radio did accept the upgrade, to version c1310-k9w7-tar.124-21a.JY.  Problem radios are running version c1310-k9w7-tar.123-8.JA

TIA

gene

1 REPLY
Cisco Employee

Re: Change channel on Aironet 1300

Hi,

Have you tried changing channel from CLI ?

Commands

AP#

conf t

int dot110

channel

int dot11 1

channel

You also have the command 'channel least-congested'

Regards,

Madhuri

616
Views
0
Helpful
1
Replies