I have quite a few 1310 Bridges setup in point to multipoint configuration with a root bridge with a sector antenna at the campus network and remote sites connecting in. I have multiple VLANs trunked onto one SSID, this allows for having multiple vlans in use at the remote site. The problem is I want to configure some remote site bridges with a different native vlan than the standard allowing me to plug the client directly into the injector and eliminate the need for a vlan aware switch. I have tried to configure the the "encapsulation dot1q VLAN# native" but this swaps the bridge group on the subinterface to a bridge-group 1 .
! Last configuration change at 01:23:08 UTC Tue Sep 15 2009 by Cisco
! NVRAM config last updated at 01:23:09 UTC Tue Sep 15 2009 by Cisco