Re: Changing the IP ADDRESS on existing controllers Management,
I agree with Leo.... the only thing is that changing IP Addresses can corrupt your WLC... I have seen it in the past. You might get lucky and won't have to, but If you start experiencing issues, then I would clear the configuration and configure it from scratch. Also, your AP's will need to find the WLC's new ip address, so don't forget to change your DNS entry if using DNS to resolve the WLC FQDN to an ip address. If you have multiple WLC's, you will need to reconfigure your mobility groupd etc.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...