Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing the Time stamp on Cisco AP's

In particular, 1200 series AP's

I cant find a link anywhere in the setup (using the GUI interface).

Thanks for the help.

Lonny

7 REPLIES
Hall of Fame Super Gold

Re: Changing the Time stamp on Cisco AP's

Use the CLI:

clock timezone

clock summer-time recurring <1, 2, 3, 4 week of the month> <1, 2, 3, 4 week of the month> .

Does this help?

Hall of Fame Super Red

Re: Changing the Time stamp on Cisco AP's

Hi Lonny,

Just to add a note to the good tips from Leo (+5 points Leo :)

From this good guide;

http://cisco.com/en/US/docs/wireless/access_point/12.4_3g_JA/configuration/guide/s43adm.html#wp1036880

Hope this helps!

Rob

New Member

Re: Changing the Time stamp on Cisco AP's

Thanks Rob, that guide only talks about using the CUI. I need to know if there's a way to configure it thru the GUI.

Not big on using the CUI as most AP's are already mounted and my understanding is you need to use the console port for CUI commands, correct?

Lonny

Hall of Fame Super Red

Re: Changing the Time stamp on Cisco AP's

Hey Lonny,

No worries!

Q. How do I change the date and time settings on the Cisco 1231 AP?

A. Go to the web interface (GUI), choose Services > SNTP, select Time Settings and then change the time.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_qanda_item09186a008009483e.shtml

Hope this helps!

Rob

PS: If enabled, you can also access the AP via Telnet and ssh for cli commands :)

New Member

Re: Changing the Time stamp on Cisco AP's

The SNTP link was the one I needed. Thanks Rob...

New Member

Re: Changing the Time stamp on Cisco AP's

Thanks Rob, that guide only talks about using the CUI. I need to know if there's a way to configure it thru the GUI.

Not big on using the CUI as most AP's are already mounted and my understanding is you need to use the console port for CUI commands, correct?

Lonny

Hall of Fame Super Gold

Re: Changing the Time stamp on Cisco AP's

If it's in Autonomous mode, you can telnet into the AP. If it's Lightweight mode, the configuration has to be done on the WLC (CLI or GUI).

239
Views
5
Helpful
7
Replies