Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

channel bonding on autonomous 1250 AP

Hello Everyone,

     I have a AP 1250 and I would like to channel bond with the 5-GHz 802.11n radio; to get more throughput. I have found some articals how to do this, but it's for the non autonomous AP GUI setup. Does anyone have the IOS commands to use and maybe an doc to go with it? Thanks

2 REPLIES
Hall of Fame Super Gold

Re: channel bonding on autonomous 1250 AP

HTML into your AP, go to Netowork Interfaces, 5GHz radio and click into the Settings Tab.

Go down to the "Channel Width" dropdown menu and choose "Above 40MHz".

For "n" to work, you need to have WPA2/AES or open authentication to work.

Hope this helps.  Please don't forget to rate our posts.

New Member

Re: channel bonding on autonomous 1250 AP

Thanks for the replay; the AP is currently using above 40MHZ and WPA2/AES. And that's were I'm standing on this channel bonding.

1029
Views
0
Helpful
2
Replies
CreatePlease to create content