AP4800 is same as AP340..Plug the ip address in the web browser like http:// 22.214.171.124
Where 126.96.36.199 is ip address of AP. After that Click on "Setup" and under "Network Ports" and "AP Radio" click on "Hardware". You will see "Default Radio Channel:" config..whre you can select channel..Pl. visit following url for more information
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...