Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

channel verify

Hi,

How can I verify what channel the Cisco 1200 AP is using? The only way I know is "show run". Is there any other way?

Thanks,

yytellmey

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: channel verify

H yytellmey,

Give this a try;

Use the show controllers dot11Radio0 command in order to show the frequency and channel that the AP or bridge is on. This example output shows where to find the information:

ap#show controllers dot11Radio0

!

interface Dot11Radio0

Radio AIR-AP1242GA, Base Address 0014.1b58.08f

Version 5.80.12

Serial number: GAM09200992

Number of supported simultaneous BSSID on Dot1

Carrier Set: Americas (US )

DFS Required: No

Current Frequency: 2412 MHzChannel 1

Hope this helps!

Rob

Please remember to rate helpful posts............

2 REPLIES
Hall of Fame Super Red

Re: channel verify

H yytellmey,

Give this a try;

Use the show controllers dot11Radio0 command in order to show the frequency and channel that the AP or bridge is on. This example output shows where to find the information:

ap#show controllers dot11Radio0

!

interface Dot11Radio0

Radio AIR-AP1242GA, Base Address 0014.1b58.08f

Version 5.80.12

Serial number: GAM09200992

Number of supported simultaneous BSSID on Dot1

Carrier Set: Americas (US )

DFS Required: No

Current Frequency: 2412 MHzChannel 1

Hope this helps!

Rob

Please remember to rate helpful posts............

New Member

Re: channel verify

Thanks Rob. It is what I need.

Thanks,

yytellmey

126
Views
0
Helpful
2
Replies
CreatePlease login to create content